Socket 775 / AM2 / AM2+ / AM3

Origin
 

IFX-10, the backplate/motherboard backside CPU cooler utilizes two heatpipes and proprietary through holes from the High Riser series to additionally cools the CPU from the back of the motherboard. You can install HR-10 with any Thermalright heatsinks that is compatible with your motherboard and for older motherboards of socket 775, AM2, 939 too. IFX-10 also gives you an option of installing an 80mm fan. With IFX-10ˇ¦s additional cooling capacity, your motherboardˇ¦s life expectancy is not only increased but stability is established as well.

 

Features
  • Use high quality copper material for consistent heat absorption and transfer.
  • Utilizes six high quality 6mm heatpipes, strategically positioned to pick up the heat from the CPU.
  • Proprietary bent winglet design to minimize airflow resistance.
  • Heat pipes soldered to base (nickel plated) and fins for optimum heat transfer.
  • Stack of 52 pieces of copper fins, the most over any other heatsinks in the market. Can be covered entirely by a 120mm fan to absorb all in-coming air flow.
  • Vast compatibility list for multiple multi-core CPUs and platforms.
  • Includes both bolt-thru-board retention mechanisms for Intel 775 and AMD AM2 (backplate included for both platforms).
  • Includes two sets of fan wire clips for a duo-120mm fan installation (fans not included).
  • Includes the NEW thermal paste, Chill Factor 2 for even better conductivity.

Technical Spec

  • Dimension: L134.5 x W163 x H112 (mm)

  • Weight: 130g (heatsink only)  Recommended Fan (80x25mm

Graphics Cards Compatibilities
Socket 775 Socket 939
Socket AM2
Socket AM2 +
Socket AM3

CPU Cooler Compatibilities


Ultra-120 eXtreme,Ultra-120A,HR-01 Plus,

HR-01,SI-128,SI-128 SE,Ultima-90,Ultra-90.and Any push pin 775 Cooler

Case Compatibilitie
  • Before installation of IFX-10 backside cooler, please make sure that you have at least 70mm of space for the backside cooler to extend beyond the motherboard. Please click here for illustration.

Performance Test


System Used
Processor: Intel E6300 1.2V
Processor Cooling: intel Stock cooler + IFX-10
Motherboard: ASUS P5B-D
RAM: Teamgroup DDR2 800 1GB*2
Hard Drive: Seagate 80GB
Graphics Card:7900GTO

IFX-10 FAQ

Iˇ¦m interested in getting a IFX-10 but how can I determine if IFX-10 will fit inside my case?

Before installation IFX-10 backside cooler, please make sure that you have at least 70mm of space for the backside cooler to extend beyond the motherboard.
1. A typical ATX case with room to spare next to the power supply unit for the backside cooler to be installed.


 

2. Special cases such as the BTX form factor leave limited space between the motherboard and the power supply unit with no room for the backside cooler to be installed.

Copyright c 2003 Thermalright Inc. All rights reserved.