Disclaimer:
Thermalright or its owners or partners
is not responsible for damage or loss
of any kind that may occur as a result
of using or misusing this or any product
we manufacture. Use common sense and
review all product details prior to
use. Ask a question
775 Installation
- STEP 1-
- STEP 2-
Ultra-120 and
its accessory parts
Socket 775
motherboard.
- STEP 3 -
- STEP 4 -
First,
install 775 backplate on the back of the motherboard.
Place the
anti-vibration adhesive strip on each side of the
heatsink.
- STEP 5 -
- STEP 6 -
Insert one
end of fan wire clip at the top of the heatsink into where its designated hole
is.
Insert the
other end of fan wire clip at the bottom of the heatsink into where its
designated hole is.
- STEP 7 -
- STEP 8 -
Anti-vibration adhesive strips and fan wire clips
installed.
Anti-vibration adhesive strips and fan wire clips
installed.
- STEP 9 -
- STEP 10 -
Apply a thin
layer of thermal paste on the CPU and on the base of the
heatsink.
Put the
heatsink on top of the CPU.
- STEP 11 -
- STEP 12 -
Install the
spring loaded screws onto the 775 bracket mount.
Secure the
120mm fan by hooking the fan wire clip into the designated hole on the
fan.
- STEP 13 -
- STEP 14 -
Plug in the
120mm fan to the fan power outlet on the motherboard.
Installation
complete.
K8 Installation
- STEP 1-
- STEP 2-
Ultra-120 and
its accessory parts
Socket 939
motherboard system
- STEP 3 -
- NOTE-
Remove socket
939 K8 stock RM
If your
backplate is of plastic (such as in the case for some Gigabyte and DFI
motherboards), replace it with a metal backplate before going to the next
step.
- NOTE -
- STEP 4-
If you have
the metal backplate (ASUS or MSI), please proceed to next
step.
Place the
anti-vibration adhesive strip on each side of the
heatsink.
- STEP 5-
- STEP 6-
Insert one
end of fan wire clip at the top of the heatsink into where its designated hole
is.
Insert the
other end of fan wire clip at the bottom of the heatsink into where its
designated hole is.
- STEP 7 -
- STEP 8 -
Anti-vibration adhesive strips and fan wire clips
installed.
Apply a thin
layer of thermal paste on the CPU and on the base of the
heatsink.
- STEP 9 -
- STEP 10 -
Put the K8
bracket mount through the heatsink.
Put the
heatsink on top of the CPU.
- STEP 11-
- STEP 12 -
Install the
spring loaded screws onto the K8 bracket mount in two separate
places.
Secure the
120mm fan by hooking the fan wire clip into the designated hole on the
fan.
- STEP 13 -
- STEP 14 -
Plug in the
120mm fan to the fan power outlet on the motherboard.
Installation
complete.
Copyright c 2003 Thermalright
Inc. All rights reserved.
