Disclaimer:
Thermalright or its owners or partners
is not responsible for damage or
loss of any kind that may occur
as a result of using or misusing
this or any product we manufacture.
Use common sense and review all
product details prior to use. Ask
a question
HR-11 + VGA Stock Cooler Installation
- STEP 1-
- STEP 2-
Use
thinner screws if installing HR-11
with stock cooling. Use thicker
screws if with V2. No screws are
needed if for HR-03 series.
Before
installation, peel off protective
film.
- STEP 3 -
- STEP 4 -
Remove
stock cooler¡¦s screws.
Install
HR-11 in an angle to best fit
your system configuration.
- STEP 5 -
After
choosing the best position, tighten
screws to secure in place.
V2+HR-11 Installation
- STEP 1-
- STEP 2-
Apply
thin layer of thermal paste to
heatsink base and GPU. Then place
the heatsink on top of GPU and
line up with GPU mounting holes.
After
choosing the best position for
your HR-11, tighten screws to
secure HR-11 and V2 in place.
- STEP 3-
Installation
of V2 and HR-11 complete.
HR-03 Rev.A + HR-11 Installation
- STEP 1-
- STEP 2-
To
install HR-11 with HR-03, Installation Type 2 of HR-03 must be used. Installation
of HR-11 begins when Step 1 to
Step 6 of HR-03 are followed.
Have
the HR-11 base inserted through
the screws and then apply the
spacer/washer supplied from
- STEP 3 -
- STEP 4 -
Apply
the nuts/screw caps to complete
the installation.
