Installation Guide
Installation
 
- DETAILS -

Detail drawing
Heatsink installation
120mm fan installation
92mm fan installation

¡@
Disclaimer:
Thermalright or its owners or partners is not responsible for damage or loss of any kind that may occur as a result of using or misusing this or any product we manufacture. Use common sense and review all product details prior to use. Ask a question


Heatsink installation

- STEP 1-
- STEP 2-
T-Rad2 and its included accessories.
First, you will need to remove stock cooler

- STEP 3 -
- STEP 4 -
Remove the screws (circled in red) from the back of the video card.
Remove stock cooler

- STEP 5 -
- STEP 6 -

After removal of stock cooler, it is vital to thoroughly clean off the paste and any residue for best contact and adhesiveness. Thoroughly clean thermal paste off the GPU & RAM chips.(How to clean off thermal paste?)

Peel off the backing off the RAM heatsinks and stick them to each RAM chips.

- STEP 7-
- STEP 8-
Install the included VRM-Heat sinks.

Remove the T-Rad2 base sticker


- STEP 9-
- STEP 10-
Apply a thin layer of thermal paste to top of the GPU & to the bottom of heatsink base.
Insert screws through the holes on the heatsink from the bottom side with the shorter end of shred going in first.

- STEP 11-
- STEP 12-
Insert the white washers through the screws
Place the T-Rad2 on top of the GPU then Insert the black washers through the screws on the other side.

- STEP 13-
- STEP 14-
Turn the nuts to tighten.
Installation completed.

120mm fan installation
- STEP 1-
- STEP 2-
Align the fan mounting holes to the 120mm fan holes on the T-Rad2 (holes shown as red circles). Note: It¡¦s ok that the fan extends past the heatsink body on the other side.
Secure the fan by tightening on the screws.

- STEP 3 -
- STEP 4 -
Hook one end of the 120mm fan wire clip into the fan mounting hole as depicted in the illustration.
Hook the other end of the 120mm fan wire clip into the heatsink to finish 120mm fan installation.


92mm Fan Installation
- STEP 1-
- STEP 2-
Insert the screws through the fan mounting hole to the hole on the heatsink body and tighten on the screws to secure fan in place.
Do the same to 7 other holes.
Copyright c 2003 Thermalright Inc. All rights reserved.