VRM-R5 Heatsink installation
 
- DETAILS -

Detail drawing
Disclaimer:
Thermalright declares : to all user and possessor of Thermalright's products , please read the instruction sheet and details carefully prior installation of our products, . Any damage or loss caused by misuse or incorrect usage of our products or accessories , will not be responsible by Thermalright.


VRM-R5 VGA cooler installation instructions

  
- STEP 1-
- STEP 2-

Before Installing VRM-R5, you will need to first have your Spitfire installed on your VGA, and then clean and rub off thermal paste and residue neat the VRM chip area to ensure the best thermal conductivity.

Take out the Thermal pad from the accessory pack, and pill-off the protection sticker on both side of the Thermal pad.

- STEP 3 -
- STEP 4 -
Place the thermal pad in the area marked in red as shown above, and make sure that the thermal pad is placed flat.
Place the protection plastic washer over the thumbscrew.

- STEP 5 -
- STEP 6 -
Align R5 with the mounting holes on the VGA, and tighten the thumbscrews with even force.
Installation completed!

Copyright c 2003 Thermalright Inc. All rights reserved.